Please enable javascript, or click here to visit my ecommerce web site powered by Shopify.

Community Forum > Dell PERC6/i Question

Hello, im pretty new to the quantastor system. So far its pretty awesome im just having a set up issue. i created the raid 1 drive for boot on the dell PERC6/i and this is installed and working. then i installed my two 500 gb drives and they wont show up on the physical disks tab on the admin page. do i have to put the all into virtual drives? i would not like to do that so i can use the built in raid systems. please help if you can!
thanks!

May 21, 2015 | Registered CommenterGage Lindell

Hello Gage,

If your RAID controller supports passthrough for the disks, you could configure them so that they show up as standard disks, Otherwise you would need to configure the disks as a Virtual Drives to have them show up in the Physical Disk view of the QuantaStor WebUI.

Thank You,
Chris Golden
OSNEXUS Support

May 21, 2015 | Registered CommenterChris Golden